粗大浓稠硕大噗嗤噗嗤h,精品人妻码一区二区三区,国产av无码专区亚洲精品,日韩a片无码毛片免费看小说

1、啟動時保持適當?shù)膯?dòng)速度，不應過猛。
2、注意觀察電壓表的電壓，若低于限制電壓時，叉車應立即停止運行。
3、叉車在行走過程中，不允許扳動方向開關而改變行駛方向，以防燒壞電器元件和損壞齒輪。
4、行駛與提升不宜同時進行。
5、注意驅動系統，轉向系統的聲音是否正常，發現異常聲音要及時排除故障，嚴禁帶病作業。
6、轉變時要提前減速。
7、在較差道路情況下作業時，其重要適當減輕，并應降低行駛速度。
Operating rules
1, starting to maintain proper starting speed, should not be too fierce.
2. Pay attention to the voltage of the voltmeter. If the voltage is lower than the limit, the forklift should stop running immediately.
3, forklift in the process of walking, not allowed to pull the direction switch, and change the direction of travel, in order to burn out electrical components and damage gear.
4, driving and promotion should not be carried out simultaneously.
5, pay attention to drive the system, steering system sound is normal, abnormal sound should be found out in time, is strictly prohibited operation.
6, slow down in advance.
7, in the poor road conditions, the operation of the importance of appropriate mitigation, and should reduce the speed of travel.
       天有不測風云，人有旦夕禍福，單獨一個人能有多大能量？能應付得了危機重重，千變?nèi)f化的困境？即使單獨一人取得了巨大的成功，擁有了億萬財富，若沒有幾個“鐵桿哥們”同甘苦，共患難，又有什么價值？
 
       各顯各的神通，群體一起過海，互相欣賞，相互照應，就象變形金剛那樣，分開，可各自獨自作戰，協同作戰，合攏，就是一個戰無不勝的金剛體。不熱愛群體的人生是寂寞孤獨的可憐人生。

1、起重前必須了解貨物的重量，貨重不得超過叉車的額定起重量。
2、起重包裝貨物時應注意貨物包扎是否牢固。
3、根據貨物大小尺寸，調整貨叉間距，使貨物均勻分布在兩叉之間，避免偏載。
4、貨物插入貨堆時門架應前傾，貨物裝入貨叉后，門架應后傾，使貨物緊靠叉壁，并盡可能將貨物降低然后方可行駛。
5、升降貨物時一般應在垂直位置進行。
6、在進行人工裝卸時，必須使用手制動，使貨叉穩定。
7、行走與提升不允許同時操作。
8、在大坡度路面運載貨物時，注意貨物在貨叉上的牢固程度。
Matters needing attention

1, lifting must understand the weight of the goods, goods weight shall not exceed the lifting weight of forklifts.

2, lifting the packaging of goods should pay attention to the cargo bandage is firm.

3, according to the size of goods, adjust the fork spacing, so that the goods evenly distributed between the two forks, to avoid partial load.

4 when the goods are inserted into the cargo heap, the door frame shall lean forward and the goods are loaded into the cargo fork. The door frame shall be bent backward so as to make the goods close to the fork wall, and reduce the goods as much as possible, and then drive.

5, the lifting of goods in general should be carried out in a vertical position.

6, in manual handling, you must use hand brake, so that fork stability.

7, walking and lifting are not allowed to operate simultaneously

8, in the large slope of the road carrying goods, pay attention to the cargo on the fork firmly.