DBX 386 雙通道電子管話放
DBX 386
高阻抗,4 / 1“儀器輸入位于前面板,以及麥克風/線路開關,和20分貝墊顯示我們的奉獻,提供方便的工作室。12段為一眼就可提供一個模擬或數字水平的視覺指示。
銀系列386雙通道麥克風前置放大器提出兩全其美的替代真空管的溫暖與專有的dbx®IV型™轉換系統結合成一個實惠的套餐。386有許多相同的功能,其他產品在銀系列,如+48V幻象電源,相位反轉開關,和低切濾波;也包括兩AES/EBU數字輸出,以及S/PDIF格式。
高阻抗,4 / 1“儀器輸入位于前面板,以及麥克風/線路開關,和20分貝墊顯示我們的奉獻,提供方便的工作室。12段為一眼就可提供一個模擬或數字水平的視覺指示。后面板包括麥克風和線路輸入和輸出,字時鐘同步輸入和輸出,和數字輸出。添加可選采樣率44.1 kHz,48 kHz,88.2 kHz,或96千赫;可選的抖動和噪聲整形;和獨立的模擬和數字輸出控制,這已經令人印象深刻的功能列表,我們認為你會同意386辜負創新dbx®標準。
推薦:工作室。
特點:
A : 雙通道電子管話放
B:數字采樣頻率支持96、88.2、48、44.1KHZ
C:數字量化精度支持24、20、16BIT
D:可選擇抖動和噪聲形狀
E:AES/EBU數字接口輸出
F:字時鐘同步輸入輸出
G:可對模擬和數字輸出信號的單獨調整
H:Type IV轉換技術
I:60dB的輸入增益和+/-15dB的輸出增益
J:話筒和線路的可選切換
K:48V幻象供電
L:20dB固定衰減
M:75HZ低頻濾波
N:反相設置
O:數字和模擬信號的LED電平指示燈
386技術參數:
話筒輸入:
連接口: 母頭 卡農 Pin 2 Hot
支持類型: 平衡/非平衡
阻抗: 330Ω
最大輸入電平: -9 dBu 或 +11 dBu 帶有20 dB固定衰減模式
線路輸入 (后面板)
連接口: 大三芯 1/4" Jack
支持類型: 平衡/非平衡
阻抗: 20kΩ 非平衡, 40kΩ 平衡
最大輸入電平: +21dBu平衡或者非平衡
增益控制: -15dB 到 +15dB
樂器輸入(前面板)
連接口:大兩芯 1/4" Jack
支持類型: 非平衡
阻抗: 470kΩ
最大輸出電平: >+21 dBu 非平衡
獨立Insert接口: 大三芯 1/4"
支持類型: 非平衡
阻抗: 100Ω, 發送 -20Ω 返回
模擬輸出
連接口: 工頭卡農 Pin 2 Hot 和 大三芯 1/4"
支持類型: 平衡或者非平衡
阻抗: 平衡 120Ω, 非平衡 60Ω
最大輸出電平: >+21 dBu, >+20 dBm (到600Ω負載)
數字輸出
連接口: AES/EBU卡農口、S/PDIF蓮花口
阻抗: 110Ω (AES/EBU), 75Ω(S/PDIF)
字時鐘同步
連接口: BNC
輸入阻抗: 75Ω 終止內部跳線
輸入: 96, 88.2, 48, 44.1kHz 字時鐘
輸出: 96, 88.2, 48, 44.1kHz 字時鐘
系統性能
控制范圍: +30dB 到+60dB (話筒輸入)
-15dB 到 +15dB (線路和樂器輸入)
電平控制面板
(模擬和數字): -15dB 到 +15dB
線路: 可在卡農或者線路中間選擇
幻象供電: +48V
固定衰減: 20dB
反相: 反轉 pins 2和 3(話筒輸入)
低切: 75Hz, 12dB/倍頻程高通濾波
頻率響應: <10Hz 到 75kHz
總諧波噪聲: 0.35% 標準 在 +4dBu 輸出, 1kHz, 40 dB 增益
內部信號交錯: 一般 –80dB, 20Hz 到 20kHz
模擬轉換到數字信號
支持類型: dbx? Type IV? A/D 轉換系統
采樣率: 96, 88.2, 48, 44.1kHz 可選
字長: 24, 20, 16 bit 可選
抖動類型: TPDF, SNR2, 或無
噪聲類型: Shape 1, Shape 2, 或無
輸出類型: S/PDIF 或 AES/EBU
轉換的動態范圍: 107dB 標準, A-weighted, 22kHz 頻寬
電源支持
電壓: DO: 120VAC 60Hz, 100VAC 50/60Hz
EU: 230VAC 50/60 Hz
電源功率: 35W
形狀
體積: 1.75'' x 7.75'' x 19'' (4.5cm x 19.7cm x 48.5cm)
The Silver Series 386 dual channel tube mic preamp puts the best of both worlds into one affordable package by combining the warmth of the irreplaceable vacuum tube with the proprietary dbx® Type IV™ conversion system. The 386 boasts many of the same features as other products in the Silver Series, such as +48V phantom power, a phase invert switch, and low cut filtering; but also includes digital outputs in both AES/EBU, and S/PDIF formats.
The high impedance, 1/4" instrument input located on the front panel, as well as the mic/line switch, and 20 dB pad show our dedication to providing convenience in the studio. The 12 segment LED meters provide a visual indication of analog or digital levels at a glance. The rear panel includes both mic and line inputs and outputs, word clock sync input and output, and digital outputs. Add selectable sampling rates of 44.1 kHz, 48 kHz, 88.2 kHz, or 96 kHz; selectable dithering and noise shaping; and separate analog and digital output controls to this already impressive list of features, and we think you’ll agree that the 386 lives up to the innovative dbx® standards.
Recommended for: Studio.
Features
Two channel tube microphone preamplifier
Selectable 96kHz, 88.2kHz, 48kHz, or 44.1kHz sampling rate
24, 20, and 16-bit wordlengths
Selectable dither and noise shaping
AES/EBU and S/PDIF digital outputs
Word clock sync input and output
Separate analog and digital output control
Type IV™ conversion system
60dB of gain and +/- 15dB of output gain
Selectable mic/line switch
48 volt phantom power
20dB pad
75Hz low cut filter
Phase reverse
Segment LED analog/digital
Mic Preamp Connector | Female XLR Pin 2 Hot; Electronically balanced/unbalanced |
Mic Preamp Input Impedance | 330Ω |
Mic Preamp max input level | -9 dBu or +11 dBu with 20 dB pad engaged |
CMRR | >40dB, Typically 55dB |
Mic Preamp Equivalent Input Noise (EIN) | Typically -120 dBu with a 150Ω source load, 20Hz to 20kHz BW |
Input Connectors | (instrument/line) 1/4" Jack |
Input Type | (line) Electronically balanced/unbalanced; (instrument) Unbalanced |
Max Input | (instrument/line) +21dBu balanced or unbalanced |
Gain Adjustment Range | (drive control) Line/Instrument: -15dB to +15dB; Mic: +30dB to +60dB |
Output Connectors | Male XLR Pin 2 Hot and TRS 1/4" |
Output Type | Servo-balanced/unbalanced |
Output Impedance | Balanced 120Ω, unbalanced 60Ω |
Max Output | >+21 dBu, >+20 dBm (into a 600Ω load) |
Digital Output Connector | XLR for AES/EBU, RCA for S/PDIF |
Digital Output Impedance | 110Ω for AES/EBU, 75Ω for S/PDIF |
Word Sync I/O Connectors | BNC |
Word Sync Input Impedance | 75Ω terminated by internal jumper |
Word Sync Input | 96, 88.2, 48, or 44.1kHz word clock |
Word Sync Output | 96, 88.2, 48, or 44.1kHz word clock |
Output Level | -15dB to +15dB |
Line Switch | Selects between microphone and line inputs |
Mic Preamp Phantom Power | +48V |
Pad Switch | 20dB pad |
Phase Invert Switch | Reverses pins 2 and 3 of the microphone input XLR |
Low cut Switch | 75Hz, 12dB/octave high pass filter |
Frequency Response | (analog) <10Hz to 75kHz |
THD+Noise | 0.35% typical at +4dBu out, 1kHz, 40 dB gain |
Interchannel Crosstalk | Typically –80dB, 20Hz to 20kHz |
A/D Converter | dbx® Type IV® A/D Conversion System |
Sample Rate | 96, 88.2, 48, or 44.1kHz selectable |
Wordlength | 24, 20, or 16 bit selectable |
Dither Type | TPDF, SNR2, or none |
Noise Shape | Shape 1, Shape 2, or none |
Digital Output | S/PDIF or AES/EBU |
Digital Output Dynamic Range | 107dB typical, A-weighted, 22kHz bandwidth |
Operating Voltage | DO: 120VAC 60Hz, 100VAC 50/60Hz; EU: 230VAC 50/60Hz |
Power Consumption | 35W |
Dimensions | 1.75'' x 7.75'' x 19'' (4.5cm x 19.7cm x 48.5cm) |
Unit Weight | 6.89 lbs (3.17kg) |
Reference | 0dBu = -16dFS, 0dBu-0.775Vms |