Specifications for SP-45000-CXP4 Spark Series
Specifications SP-45000-CXP4
SP-45000M-CXP4-F
SP-45000M-CXP4-M42
SP-45000C-CXP4-F
SP-45000C-CXP4-M42
44.7 megapixel monochrome camera - F-mount
44.7 megapixel monochrome camera - M42 mount
44.7 megapixel color camera - F mount
44.7 megapixel color camera - M42 mount
Ordering Information
Dimensions
Connector pin-out
DC In / Trigger Auxiliary Connector
HIROSE HR10A-10R-12PB(71)
Pin 1 Ground
2 DC in +10V to +25V
3 Ground
4 NC
5 Opto In 1-
6 Opto In 1+
7 Opto Out 1-
8 Opto Out 1+
9 TTL Out 1
10 TTL In 1
11 DC in +10V to +25 V
12 Ground
Spectral response
Wavelength (nm)
Absolute QE (%)
Visit our website on www.jai.com
Europe, Middle East & Africa Asia Pacific Americas
Phone +45 4457 8888 Phone +81 45 440 0154 Phone (Toll-Free) 1 800 445 5444
Fax +45 4491 8880 Fax +81 45 440 0166 Phone +1 408 383 0300
Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners.
JAI A-S Cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notice. March 2022
Outside size tolerance ± 0.3 mm
F-mount shown. For M42 mount dimensions, consult the manual.
Sensor 44.7-megapixel, super 35 mm CMOS global shutter
Active pixels 8192 (h) x 5460 (v)
Frame rate
Full frame
8K format (8192 x 4320)
51 frames/sec. @ 8-bit mono/Bayer
65 frames/sec @ 8-bit mono/Bayer
HDR Mode operates at < half speed
Active area 26.2 mm (h) x 17.4 mm (v) - 31.5 mm diagonal
Pixel size 3.2 μm x 3.2 μm
Readout modes
Full
ROI (single)
ROI (multi)
Binning
8192 (h) x 5460 (v) up to 51 fps
H: 128 - 8192 pixels in 128-pixel steps
V: 8 to 5460 lines in 4-line steps
Up to 64 scanning areas - no overlap
1x2, 2x1, 2x2 (mono only)
EMVA 1288 Parameters
Absolute sensitivity
Maximum SNR
12-bit output format
Mono: 8.92 p Color: 10.14 p (l = 531 nm)
Mono: 39.0 dB Color: 37.3 dB
Traditional SNR* >58 dB mono, >54 dB color (0 dB gain, 10-bit)
Video signal output Monochrome: 8/10/12-bits?
Color: 8/10/12-bit Bayer?
Special built-in modes Overlay mode, HDR (High Dynamic Range), Frame
Integration. Supports 14-bit output in some modes
Interface CoaXPress v2.0 (CXP-6, DIN 1.0/2.3 connectors)
Link Configs: CXP6_X4, CXP6_X2, CXP6_X1
CXP3_X4, CXP3_X2, CXP3_X1
Gain Manual/auto 0 dB to +24 dB
White balance Off, presets (4000K, 4600K,5000K, 6500K, 7500K),
or one-push/continuous AWB (3000K to 9000K)
Gamma/LUT 0.45 to 1.0 (9 steps) or 257-point programmable LUT
Shading correction Flat shading, color shading (color model only)
Trigger input Opto In, TTL In (2), CoaXPress In, Software, Pulse
Generators (4), NAND Out (2), User Output (4)
Exposure modes Timed/EPS, Trigger Width, Auto
Electronic shutter Timed: 50.4 μs to 8 s
Trigger width: 50.4 μs to ∞ s
Auto Level Control (ALC) Shutter range from 100 μs to 19.6 ms,
gain range from 0 dB to +24 dB.
Tracking speeds and max. values adjustable.
Operating temp. (ambient) -5°C to +45°C (20 to 80% non-condensing)
Storage temp. (ambient) -25°C to +60°C (20 to 80% non condensing)
Vibration 10G (20 Hz to 200 Hz, XYZ directions)
Shock 80G
Regulations CE (EN 55032:2015, EN 55035:2017)
FCC Part 15 Class B, RoHS/WEEE, KC
Power +10V to +25V DC. 12.5 W typical @ +12 V
(PoCXP not supported)
Lens mount F-mount, M42 mount (45.5 mm FBD)
Lens control RS-232C commands via Birger Mount
Dimensions (H x W x L) 62 mm x 62 mm x 84.2 mm (excl. connectors)
Weight 330 g/340 g (F-mount/M42 mount)
Type: 3260-10S3(55) HIROSE or equivalent
*Traditional SNR is based on random noise in a single frame, where EMVA SNR measurements
consider more comprehensive noise sources and variance over time.
?12-bit output only available in video processing bypass mode. See manual for details.
Pin Signal Note
1 TTL Out 2 Line 8
2 NC
3 TTL In 2 Line 10
4 NC
5 GND GND
6 Lens Power DC 9V
7 RS-232C Tx For lens control
8 RS-232C Rx For lens control
9 GND
10 GND
